Sensors
About MACE Doppler ultrasonics and MASP technology
True average velocity measurement with MASP Technology. MACE velocity sensors use continuous wave Doppler ultrasound to measure the speed of dirt, bubbles and other particles in the stream flow.
MACE Doppler ultrasonic velocity sensors utilizing MACE Advanced Signal Processing (MASP) technology “see” across the entire stream profile to give a true average velocity.
Doppler ultrasonic insert velocity sensor
For use in full pipes or partially full pipes when used in conjunction with an EchoFlo depth sensor. Insertion sensors measure velocity only and require access to the outside wall of the pipe in which the sensor is to be mounted. These sensors can be installed into existing pipework through a 2″ ball valve (recommended) or just through a 2 inch female thread fitting.
> Download product flyer (PDF)
Tech Specs:
Nickel plated Brass
100mm (4″) to 2500mm (100″)
400mm (15.7″) L x 45mm (1.8″) dia. x 25mm (1″) H
Either 2″ BSP or 2″ NPT
MACE Doppler Card
How to install:
Doppler ultrasonic velocity sensor
Velocity sensor for use in full pipes or open channels when used in conjunction with a depth sensor. This sensor is used to measure velocity only in full pipes when access to the pipe is available and the pipe can be emptied when installation or maintenance is required. It can also be used in partially full pipes or open channels in situations where the user is measuring depth by a third party or ultrasonic depth sensor.
> Download product flyer (PDF)
Tech Specs:
PVC and Epoxy
150mm (6″) to 2500mm (100″)
125mm (5″) L x 50mm (2″) W x 16mm (0.62″) H
MACE Doppler Card
Use a MACE ZX SnapStrap to install this sensor inside a pipe in minutes. The polycarbonate ZX Snapstrap is tough, secure, does not foul and can be easily removed to take the sensor to another site.
Doppler ultrasonic area/velocity sensor
Combined velocity and depth sensor for use in partially full pipes or open channels. This sensor is used in open channels or pipes that run partially full. This sensor is used to measure depth (using a capacitive pressure diaphragm) and velocity. Access to the monitoring point is required for installation and maintenance.
> Download product flyer (PDF)
Tech Specs:
PVC and Epoxy
150mm (6″) to 2500mm (100″)
125mm (5″) L x 50mm (2″) W x 16mm (0.62″) H
2m (79″), 4m (158″)
MACE Doppler Card
Use a MACE ZX SnapStrap to install this sensor inside a pipe in minutes. The polycarbonate ZX Snapstrap is tough, secure, does not foul and can be easily removed to take the sensor to another site.
How to install:
EchoFlo ultrasonic depth sensor
The MACE EchoFlo features patented DSP technology that allows level measurement in a limited space. With a minimal 2″ (50mm) dead band and narrow beam-width, the EchoFlo can be deployed in a diverse range of applications. These include: wastewater flow measurement through flumes (coupled with a MACE FloPro XCi, AgriFlo XCi or HydroMace XCi); level measurement in small tanks and sumps; depth measurement in pipes; and any number of other control automation applications where non-contact level measurement is desirable or necessary.
The MACE EchoFlo is easy to configure using the free EchoCal software and is economical to purchase and install.
> Download product flyer (PDF)
Tech Specs:
Polycarbonate and PVDF
1.25m (49.2″) or 2.5m (98.4″)
MACE I/O Card
1″ NPT